Description
MAIN FEATURES
Just had your RCD330 or RCD360 fitted but are suffering issues like the unit won’t turn on and off with the keys? Bluetooth message about the ignition but it is on? Well the reason this happens is because the RCD330 and RCD360 are both on the PQ6.5 platform with CANBUS 2.0. Your vehicle is suffering with these issues because it is on CANBUS 1.4. So how do you solve this? We have the solution here with our decoder simulator.
It will solve the following problems:
- Turns off every 30 minutes
- Buttons don’t light up
- Avoid Battery Drain
- Can not turn off even if the key is removed
- No reverse image
- Bluetooth can not work
This is only suitable for VW models between 2010 and 2019. It will not be suitable for models before 2010. This item requires manual connection (it is not plug and play).
How to use it:
There are 5 inputs & 2 outputs for this device.
INPUTS
BLACK (GND) | You can connect to Brown cable on your radio’s Quadlock socket/ Any Ground point
YELLOW (+12v BATT) | You can connect to Red/Yellow cable on your radio’s Quadlock socket / Or any continuous 12V+
RED (ACC POWER) | You need to connect to a switched 12V. You can take it from Fuse box, this input must has 12V power only when you Switched ignition.
ORANGE (ILLUMINATION LIGHT) | You need to connect to 3nd pin of Light Switch of your car. (Parking light position usually grey/yellow cable)
BLUE (REAR CAMERA TRIGGER) | You need to connect to Backup Lamp. (You can find on BCM pinouts also, you need to connect when you install Reverse Camera)
OUTPUTS
WHITE (CAN +) |You need to connect your Radio’s CAN + (HIGH) input, you can check it on Radio’s label.
GREEN (CAN -) | You need to connect your Radio’s CAN – (LOW) input, you can check it on Radio’s label.
IMPORTANT NOTES:Please note that you need to replace actual CAN +/- wirings with adapter’s.
Please note that you need to connect actual CAN +/- back when you need to code your radio via VCDS/ODIS/OBD11…
Reviews
There are no reviews yet.