Dynamat Xtreme DYNXTS31D Car Door Kit – Tesla Model 3 Self Adhesive Sound Deadening Custom Cut Made to Spec

Description

MAIN FEATURES

Dynamat Xtreme Custom Cut Kits are the easiest way to make your vehicle Dynamat equipped and vibration free.

This Kit covers the inside and outside of All 4 Doors.

Each kit contains sheets of Dynamat Xtreme pre-cut to match the body panels of your vehicle. All you need to do is strip the panel ready for application, then peel and stick each sheet to the corresponding location on the vehicle. No cutting, no wastage, just the perfect amount of Xtreme to reduce the vibration noise of your truck. Dynamat Xtreme Custom Kits are sold to cover specific vehicle areas. Kits for the Tailgate compartment and Tailgate Lid are also available.

With Dynamat’s industry-leading damping technology, even partial coverage makes a noticeable impact. Just 30% panel coverage can dramatically cut down noise, but for the ultimate in soundproofing, full coverage is always an option.

When driving, the body panels of your vehicle vibrate and create noise. The faster you drive, the louder that noise will be. At 70 mph, a typical automotive noise level reaches 85 dB. This will interfere with the sounds inside your vehicle, like your stereo, cell phone calls and conversations by affecting the dynamic range of these sounds. If you want your music louder, you can turn up your stereo, but that only increases volume. It does not give you back the dynamic range you have lost. One of the main culprits of this noise is your vehicle’s doors. Without Dynamat Xtreme, vibrations resonate and echo through the hollow inner door cavity.

Since much of the noise that comes from the road enters through the doors, installing the Dynamat Xtreme Kit creates a sonic barrier that converts noise-causing vibration into silent energy. By reducing the road noise, the Dynamat Xtreme Kit can increase the dynamic range of the sounds in your car, which can effectively double your vehicle’s amplifying power! You get louder sound from your car’s audio and less annoying noise from outside your vehicle.

Fitting Notes:

• You will need to make 2 minor adjustments to this kit:
• IMAGE 1: The arrow shows the hole that needs to be cut out. The circle shows roughly where it is on the door panel
• IMAGE 2: This gives a clearer view of where the additional hole needs to be cut out
• IMAGE 3: The Dynamat must be installed around these 2 clips located at the top of the door. You will need to cut away a small amount of material.